H1000 is on my would like list of powders as well. It's possible the IMR Enduron series will likely be perfectly liked and I can transfer to that for better availability.
I've utilized H4831 (and H4831SC), And that i utilize it. There are not several cartridges that I utilize it for as I seem generally to gravitate to other powders. Having said that, I can not declare that it won't operate. It is simply that Several other powders do the job improved for any presented cartridge. By way of example, within the 280, H4831 gave me great velocity and really good teams with Nosler one hundred forty AB. Having said that, RL19 was marginally superior in precision, although the velocity was virtually identical.
What is actually the primary difference? Compression. With no Serious/significant compression associated with the long grain 7828, the pressure curve was altered and the load fell aside.
Yes it is possible to. They're the exact same precise powder however the SC powder is simply Reduce shorter so it meters superior.
Alaska The sc loads up somewhat much better but they are the very same thing, a person is just short Slice. I’ve even blended the conventional a single Using the SC and gotten the identical effects as employing a single or the other.
I do know, tough situations. H4831SC will certainly do the job, I just did not like the case density when loaded prolonged. I do not recall powder demand off the highest of my head but I was launching a Berger 168gr VLD at three,000fps that's exactly where I typically goal to get. In your case utilizing what you have (and what I should have done) I'd personally begin with the end from the bearing surface of the bullet suitable in the shoulder/neck junction, and flirt with extending seating depths from there as soon as you look for a velocity node.
You could have to generate a couple of more posts to receive cleared to complete PM's. As you reach that position I would write-up inside the categorised reloading segment to discover if anybody is in your area for just a trade.
Like reported above, similar stuff. All of that is different is the size of the kernels. I did hear somewhere that they're going to only make the SC Later on. I do not know if that is h4831sc legitimate or not but would seem sensible to me. I take advantage of SC since that's what I located in the eight lb jug and it really works.
I have observed the precise reverse to get correct in my gun. H4831SC was the slowest powder with a hundred and eighty g Accubonds. RL22 was a much faster and Similarly correct powder in my three hundred Get Mag.
Liberalism; The difficult nonetheless recognized Idea that it's fully possible to pick up a turd by the clean stop.
As for your 4831 vs 4831SC, These are exactly the same/similar powder cept for grain sizing. h4831 vs h4831sc Load data is interchangeable.
The "SC" stands for Shorter Slice. I have not noticed a distinction between either powder dut I do not Consider I would blend them.
Each provide the Exact same burn off h4831sc load data rate, limited cut comes in helpful Should you be at max fill instead of at stress/velocity that you might want you will get far more shortcut in a situation.
The container didn't possess the "Extraordinary" emblem on it. A coworker And that i then swapped some powder, and I wound up with One more pound of H4831SC, this 1 While using the "Excessive" symbol on it.